AFM 7.10.1 GENERAL – Power Generation
7.10.1 GENERAL
The DA 40 NG has a 28 Volt DC system, which can be sub-divided into:
-Power generation
-Storage
-Distribution
-Consumers
Power Generation
Power generation is provided by a 70 Ampere alternator (generator) which is mounted on the bottom left side of the engine. The alternator is driven by a flat-belt.
The power output line of the alternator is connected to the ENG ECU bus via a 100 A fuse, which is installed in the instrument panel. The power output line also runs through the current sensor, which provides an indication of the power being supplied to the electrical system by the alternator including the current for battery charging.
In the event of a main battery failure the field of the alternator is energized by two 12 V, 7.2 Ah sealed-lead-acid batteries (ECU backup batteries) which are installed behind the first ring frame. The ENGINE MASTER switch connects the ECU backup battery to the alternator voltage regulator via a 10 A fuse.
Alternator Control:
The alternator control unit includes a comprehensive set of diagnostic functions that will warn the operator using a warning message (ALTN FAIL on the G1000 system (if installed) or ALTERNATOR on the White Wire annunciator panel (if installed)) in case of over – of undervoltage as well as a couple of other internal warning levels.
7.10.1 일반
DA 40 New-Genaration 항공기는 28볼트 직류전원 시스템을 사용하고, 다음과 같이 정리할 수 있다.
-발전(發電)
-저장
-분배
-사용기기
발전(發電)
엔진 좌측 하단에 장착되어있는 70암페어 발전기에 의해 발전된다. 발전기는 평평한 밸트(플랫 밸트)에 의해 작동된다.
계기판에 설치되어있는 ECU(Engine Control Unit – 엔진 제어 장치, 이하 ECU)는 발전기의 100암페어 퓨즈를 거쳐 연결되어 있다. 전기 출력 선은 전류센서를 지나는데, 이 전류센서는 배터리를 충전하고 전기시스템에 전기를 제공하며 이를 계기 패널에 나타내는 역할을 한다.
메인 배터리가 고장이 나면 첫 번째 원형 프레임 뒤에 장착되어있는 12볼트, 7.2 암페어의 봉인된 두개의 납 축전지(ECU 백업 배터리) 를 통해 전원을 공급할 수 있다. 엔진마스터 스위치는 ECU 백업 배터리를 10A 퓨즈를 거쳐 교류 전압 조정기에 연결시켜준다.
발전기 제어:
발전기 제어 장치(alternator control unit)는 과전압, 저전압 상태 등의 몇 가지 문제에 대한 경고메시지(ALTN FAIL – G1000 (장착되어 있을시), ALTERNATOR – White Wire annunciator panel (장착되어 있을시))를 통해 경고하는 등 종합적인 진단기능을 포함하고 있다.