Comet 650R Stalling and Misfiring
한국어로 읽기 →
And here I was thinking it hadn’t been acting up lately..
The low fuel light came on so I was heading to the gas station when the engine just died. I shrugged it off, filled up, and when I tried to start it again, it died again..
It wouldn’t stall if I held the throttle, so as a stopgap, since home wasn’t far, I rode back holding the throttle.
The throttle response was fine until then, but right as I got home, bam! down to one cylinder
Misfire, bam! FI light, bam!
Ugh.. Now that I’ve brought it to Yongin I’ve had a rough look at the symptoms..


My first suspects are the plug cap and the ignition coil, but I only replaced them about 3 months ago, so I wonder if they’ve really failed already..
First, let’s check the error code..

Then the current error code is displayed on the instrument panel
(Info I learned from the Bike Tuning Mania cafe)



Back in Muan, the only thing I hadn’t replaced was the plug cap, so I assumed it was the plug cap and replaced it, but no wonder it looked perfectly fine..T_T
First, I decided to pull the spark plug to check whether it was sparking.




I was working while holding up the fuel tank without removing it, so I couldn’t take photos..T_T
I loosened the spark plug with the plug wrench, but it’s so deep down that there was just no way to pull it out =_= I tried grabbing it with the long-nose pliers I’d brought, but it was just..impossible..
I think I need a magnet T_T
So for now I put it all back together.. and came back up
The problem is there’s no ignition coil stock left anywhere haha No matter how hard I look, you just can’t be found..
They say there’s one left for the carb model. I wonder if it’s compatible since it works the same way..