Daily

AFM 7.10.1 GENERAL – Power Generation

한국어로 읽기 →

7.10.1 GENERAL

The DA 40 NG has a 28 Volt DC system, which can be sub-divided into:

-Power generation

-Storage

-Distribution

-Consumers

Power Generation

Power generation is provided by a 70 Ampere alternator (generator) which is mounted on the bottom left side of the engine. The alternator is driven by a flat-belt.

The power output line of the alternator is connected to the ENG ECU bus via a 100 A fuse, which is installed in the instrument panel. The power output line also runs through the current sensor, which provides an indication of the power being supplied to the electrical system by the alternator including the current for battery charging.

In the event of a main battery failure the field of the alternator is energized by two 12 V, 7.2 Ah sealed-lead-acid batteries (ECU backup batteries) which are installed behind the first ring frame. The ENGINE MASTER switch connects the ECU backup battery to the alternator voltage regulator via a 10 A fuse.

Alternator Control:

The alternator control unit includes a comprehensive set of diagnostic functions that will warn the operator using a warning message (ALTN FAIL on the G1000 system (if installed) or ALTERNATOR on the White Wire annunciator panel (if installed)) in case of over – of undervoltage as well as a couple of other internal warning levels.

7.10.1 General

The DA 40 New-Generation aircraft uses a 28-volt DC electrical system, which can be broken down as follows.

-Power generation

-Storage

-Distribution

-Consumers

Power Generation

Power is generated by a 70-ampere alternator mounted on the lower left side of the engine. The alternator is driven by a flat belt.

The ECU (Engine Control Unit – hereafter ECU), installed in the instrument panel, is connected through the alternator’s 100-ampere fuse. The power output line passes through the current sensor, which charges the battery, supplies power to the electrical system, and displays this on the instrument panel.

If the main battery fails, power can be supplied through two 12-volt, 7.2-ampere sealed lead-acid batteries (ECU backup batteries) mounted behind the first ring frame. The Engine Master switch connects the ECU backup batteries to the alternator voltage regulator through a 10A fuse.

Alternator Control:

The alternator control unit includes comprehensive diagnostic functions, such as warning about several problems like overvoltage and undervoltage through warning messages (ALTN FAIL – G1000 (if installed), ALTERNATOR – White Wire annunciator panel (if installed)).

Related

Leave a comment